Fiat Bravo Service Manual page 276

Bravo-Brava
Clutch
Clutch operation
18.
CLUTCH PEDAL POSITION A D J U S T ­
M E N T (for vehicles w i t h mechanical
release mechanism)
1. Measure the clutch pedal travel:
1. Pedal in end of travel position
2. Pedal in rest position
X. Pedal travel:
163 mm for 1370-1581 -1747-1929 D
Carefully measure the pedal travel to
ensure the correct clutch release (± 5
mm).
P4A007C03 P4AO07C02
3
o!nJSf
i^^^^^g
V,
PM
7 f ^ I If s \ ^ O ^ V ^ *
> / r t ii ? \ ^^ \ \
v«
^/A^l
%
| \^Sk\
^gg£H
In order to adjust the clutch pedal in the
rest position, it is necessary:
to bed in the clutch release mechanism by
fully depressing the pedal at least 5 times.
Check that the travel "X" is within the val­
ues given above. The travel is measured
with a rule by the centre line of the pedal
and corresponds to the distance between
the position in the end of travel position
(pedal in contact with the dashboard
bulkhead) and that of the pedal in the rest
position.
Any adjustment of the travel is carried out
acting on the nut and, where present, the
lock nut for the clutch cable, gearbox side.
R E M O V I N G - R E F I T T I N G CLUTCH CA­
BLE
In order to be able to release the clutch cable
it is necessary to remove the:
- Battery
- Relay holder casing
- Battery drip tray
3. Remove the nut and the lock nut, which
fix the clutch cable to the control lever (for
the 1370 version). For the 1581 - 1747 -
1929 versions, release the cable from the
anchorage on the gearbox - differential.
The diagram shows the clutch cable fitted on
the 1370 version.
P4A007C05 P4A007C04
Copyright by Fiat Auto
IX-95 - Cancels and replaces
7