Fiat Bravo Service Manual page 143

Bravo-Brava !g|
12v
Engine
Fuel system
ADJUSTING BUTTERFLY VALVE OPENING CONTROL
10.
The butterfly valve opening linkage must be adjusted properly for the Monomotronic injection system to
work properly.
Check that block (3) is fully home with link (1) disconnected from lever (2). Under these conditions
the accelerator control cable should never be taut or excessively slack so that accelerator pedal free
travel is taken up. If pedal shows free travel, adjust accelerator control cable nut and lock-nut.
Connect link (1) to head of lever (2) and warm up engine.
With accelerator pedal released (butterfly valve closed) check clearance between levers (2) and (4) is
0.2 - 0.5 mm.
If the above clearance is not as specified, loosen nuts (5) and (6) and tighten/loosen gauge (7) on link
(1).
After adjustment, check that butterfly valve is fully open with accelerator pedal pressed fully down.
Copyright Fiat Auto
41