Fiat Bravo Service Manual page 264

Engine
Fuel system
Bravo-Brava I0i
16v
10.
INTAKE CIRCUIT
Removing-refitting engine idle adjustment
solenoid valve and butterfly position sen­
sor
- Undo the fixing bolts (arrow) to remove
the engine idle adjustment solenoid valve
(1);
- undo the fixing bolts (arrow) to remove the
butterfly position sensor (2).
NOTE When refitting the butterfly position
sensor, take care that the operating
lever fitted on the butterfly shaft (3)
is above the sensor driving element
(4), as shown in the diagram.
Removing-refitting air flow meter
1. Remove the battery, disconnect the electrical connector (1) from the meter, loosen the bands (2) and
(3) fixing the inlet sleeve;
2. disconnect the blow-by sleeve (4) from the inlet sleeve, undo the two bolts (arrow) fixing the flow
meter mounting bracket and remove the assembly; then loosen the bands at the flow meter and re­
move the two sleeves.
P4A52BJ02
52
Print no. 506.670