Fiat Bravo Service Manual page 265

Bravo-Brava l£|
16v
Engine
Fuel system
10.
Removing-refitting butterfly casing
Proceed as described for the removal of the
air flow meter, removing the meter complete
with the two sleeves.
Then, proceed as follows:
- disconnect the electrical connectors from
the butterfly position sensor (1) and from
the engine idle adjustment solenoid valve
(2);
- remove the band fixing the blow-by pipe
(3), cylinder head cover side and remove
the pipe;
- undo the four bolts fixing the butterfly cas­
ing (arrow) to the inlet manifold;
- release the end of the accelerator cable
from the control lever;
- remove the coolant connecting pipes from
the inlet and outlet pipes, sealing them as
appropriate;
- lastly, remove the blow-by pipe (3) from
the butterfly casing.
Adjusting accelerator control cable
Adjust the accelerator control cable by carry­
ing out the following operations:
- loosen the lock nut at the bottom of the
bracket;
- acting on the adjustment nut (arrow), ad­
just the accelerator cable clearance;
tighten to reducee the clearance,
loosen to increase the clearance;
- when the adjustment is complete, lock the
lock nut.
Copyright by Fiat Auto
53