Table of Contents
Advertisement
5.2.10.2
Removal/Replacement
Rev. E
A. PAPER FEED KNOB (AJ-17)
1. Remove screw (AJ-19), ornamental plate (AJ-18), and kno&.
B.
PAPER FEED GEAR (AJ-74)
c.
To remove paper feed gear, perform the following:
1. Perform step A.1. at para. 5.2.10.2.
2. Remove snap ring (AJ-16), flat washer (AJ-15), and spring
(AJ-14).
(Be careful Of spring tension on washers when removing).
3. Remove paper feed gear, coupling (AJ-73) and knob coupler
(AJ-12) as one piece.
4. Loosen allen-screw (AJ-74) on PF gear and remove from PF
coupling (AJ-73).
5. For removal of remaining paper feed shaft, refer to
Figure AI-15, Section 8 and para. 5.2.9.2.A.
6. Reverse steps B.1. through B.4. to re-assemble.
The above parts are removed from shaft (AJ-37) in the following
manner:
1. Remove snap ring (AJ-39) just inside right PF chassis (AJ-30)
on shaft (AJ-37).
2. Remove snap ring (AJ-4i) from cam (AJ-40).
3. Loosen allen screws (AJ-50) on inner cam (AJ-40).
5-30
Advertisement
Table of Contents
