Table of Contents
Advertisement
RIBBON FEED - AL
2.
Left Pawl Operator Adjustment (AL-9)
(a) Set carriage (containing mounted piston, AA-80) at
extreme left margin until piston bottoms into damper
cylinder (AA-85).
(b) Set left releaser (AL-33) to the left.
(c) Loosen screw (AL-50) on left pawl operator stopper
(AL-49) and reset stopper with high side touching the
right side of the left pawl operator (See Fig. 5-17).
Tighten screw.
(
LEFT OPERATOR (AL-9)
STOPPER (AL-49)
'------- SCREW (AL-50)
WASHER'(AL-51)
Figure 5-17. LEFT OPERATOR AND STOPPER ADJUSTMENT
3.
Ad'ustment for Left and Ri ht
a.
Ribbon Feed Bar - Left Side (Fig. 5-18)
(1) Loosen both nuts (AL-103) on left side of ribbon
feed bar.
(2) Establish a gap of 0.2 mm (0.008-in.) between
washer (AL-102) and ribbon feed plate (AL-1).
(3) Tighten nuts (AL-103) up to washer while holding
gap at the same time.
5-41
Rev. E
Advertisement
Table of Contents
