Table of Contents
Advertisement
2.2
SHIPPING CRATE
The printer is shipped in a crate approximately 22 inches high,
27 inches deep and 28 inches wide.
The crate is made of weatherized,
triple-walled cardboard. When properly strapped, the packing crate and
printer is capable of fork lift operation with a seven-high stacking
capability.
Shipped with the printer are the following items:
(1)
If a special interfaceis used, the interface card is in-
cluded with the printer.
For certain interfaces such as the
RS232, a special cab1e is also shipped.
Cabling requirements
for the standard parallel interface are defined in Appendix C.
(2)
If optional vertical format unit is installed a standard
vertical format paper tape providing six line feeds (one
inch) for each vertical tab and
66
lines
(11
inches) for
each form feed code is provided.
Refer to the Operators
Manual for duplicating the existing tape, or if a different
format is desired, for generating a new tape.
(3) Documentation - All documentation describing that particular
printer is included in a plastic bag under the printer. This
documentation includes a technical manual for the printer and
any optional interface, and a notice of all approved changes
incorporated in the printer but not documented in the manual.
Please keep this documentation with the printer at all times
so that accurate information will be available for trouble-
shooting purposes.
(4)
Pin Feed Knobs - These knobs are contained in a small plastic
bag stapled to the
g~ide
bar for the pin feed unit.
(5)
Print Sample - A sample printout from that particular printer
is included in the upper paper pane.
(6)
Unpacking/Repacking and Set-Up Instruction Sheet.
2-2
Advertisement
Table of Contents
