Throttle And Choke Cables, Lever Bearings; Hydraulic Oil Filter, Change - Husqvarna Rider ProFlex 21 AWD Operator's Manual

9. Throttle and Choke Cables,
Lever Bearings
Remove the right side cover on the lever housing
(2 screws) and open the engine cover. Lubricate the
cables' free ends with the oilcan, even those by the
carburettor. Move the controls to the end points and
lubricate again.
Lubricate the joints, catches, and bearings for the
cutting unit's control levers with an oilcan.
Replace the lever housing's side cover.

10. Hydraulic Oil Filter, Change

IMPORTANT INFORMATION
Used engine or transmission oil is health-
impairing and must not be disposed of in the
ground or in nature.
Replaced filters must be handed in to the
workshop or other allotted placed for disposal.
Avoid skin contact; wash with soap and water in
case of spills.
1. Remove the oil filter. If necessary, use a filter
remover.
2. Wipe new, clean engine oil onto the seal for the
new filter.
3. Mount the filter by hand with + 3/4 turn.
4. Remove the transmission cover and fill the
transmission's oil tank, about 0.3 l oil.
See "13. Hydraulic System's Oil Level" on
page 70.
Be observant when running the engine as
described below and fill so that the tank is not
emptied.
5. Run the engine warm, manipulate the equipment
lift and power steering, and then check that there
are no leaks around the oil filter seal.
6. Check the oil level in the transmission, top up if
necessary. The oil filter holds 0.3 litres of oil.
7. Replace the transmission cover.
68
English-
LUBRICATION
8009-349
8009-677
8009-350