Throttle And Choke Cables, Lever Bearings; Front Wheel Mount; Front Wheel Bearings; Deck Belt Pulleys - Husqvarna LZ30, LZ30C Operator's Manual

Throttle and Choke Cables, Lever Bearings

Lubricate the cable ends by the carburetor with the oil
can. Move the controls to the end points and lubricate
again.
The throttle cable is also lubricated by the control
when the control console is removed.
On Kohler engine the cables are placed under the air
fi lter housing.

Front Wheel Mount

Lubricate with a grease gun, one zerk for each wheel
mount, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.

Front Wheel Bearings

Lubricate with a grease gun, one zerk for each set of
wheel bearings, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.

Deck belt pulleys

Lubricate with a grease gun two strokes.

Mower Deck Height Adjuster

Lubricate using a grease gun, one zerk, until the
grease squeezes out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
LUBRICATION
Lubricating the front wheels
Deck belt pulley
Lubricating the cutting height adjuster
8011-573-
8011-461
8011-574
55
-
English