Driver's Seat; Throttle And Choke Cables, Lever Bearings - Husqvarna Rider ProFlex 21 Operator's Manual

9. Driver's seat

PF 18
Tilt the seat back.
Lubricate the links to the seat's scissor suspension
with an oil can, 8 lubrication points.
Lubricate the lengthways adjustment mechanism
with the oil can.
Lubricate the lengthways adjustment runners with
the oil can.
PF 21
Tilt the seat back.
Lubricate the lengthways adjustment mechanism
with the oil can.
Lubricate the lengthways adjustment runners with
grease. Pull the seat back and forth and lubricate on
both sides.
10. Throttle and choke cables,
lever bearings
PF 18
Remove the right side cover on the lever housing
(3 screws) and open the engine cover. Lubricate the
cables' free ends with the oil can, even those by the
carburettor. Move the controls to the end points and
lubricate again.
Lubricate the joints, catches, and bearings for the
cutting unit's control levers with an oil can.
Note risk for incorrect assembly: The fine threaded
screw on the side cover should be fitted from the
outside.
Replace the lever housing's side cover.
LUBRICATION
PF 18
PF 21
PF 18
PF 18
8009-172
8009-347
6020-050
8009-157
67
English-