Konica Minolta bizhub 501 Network Operating Instructions page 357

Appendix
Term
Relay broadcast
Relay distribution station
Relay instruction station
Resolution
Scan size
Sender Fax No.
Sender Name
Sending
Sub-scanning direction
Super G3 (SG3)
Temporary Forward transmission
Timer TX
Transmission reservation
Transmission source record
Transmission speed
Transmission time
TSI
V. 34
Z-Folded Original
bizhub 501/421/361 (Version 2)
Definition
This is a function to send the broadcast the fax via other fax (called "relay dis-
tribution station"). When there are multiple broadcast destinations at distant
places, one of the broadcast destination is specified to the relay station and
the entire amount of the communication charges can be reduced by doing the
relay transmission from the relaying station.
A feature to broadcast the fax to the relay distribution destination by receiving
the relay request from the relay instruction station.
The fax machine that sends the relay broadcast request.
An index for scanning granularity. The higher the value, the finer the quality and
the longer the transmission time becomes. Select an optimal resolution for the
purpose.
This is a function to specify the scanning size of a document and transmitting
it. If the width of the paper in the recipient's fax machine is smaller than that of
the transmitted document, the fax is normally reduced when it is printed. If you
do not wish to reduce the fax, specify a document size that is same as the size
of the paper in the recipient's fax machine in order to send the fax at its original
size.
The identifying code for the mutual recognition when transmitting faxes. Nor-
mally the fax number is registered as the fax ID.
The name assigned to the local machine. On the recipient machine, this name
is printed as a part of the sender stamp at the edge of the transmitted text.
Making a call. Regarding fax operations, it is to send an original or to dial for
polling.
The vertical direction for scanning the original.
This is a G3 communication mode compliant with ITU-T V.34. The communi-
cation can be carried out at a higher speed (max. 33,600 bps) than that of the
usual G3 communication.
This is a function to manually forward the received document on hold, by using
the setting confirmation button of the control panel. The transmission is used
when the fax/scan screen is been displayed, or the operation is being stopped
due to paper misfeed or running out of paper.
This function performs transmission jobs at a preset time. It is economical to
communicate using telephone discount rate hours in early morning and late at
night.
This is a function to reserve the next transmission while current transmission
or printing.
When a fax has been sent, the transmission time, name, telephone number,
page number that is to be printed at the edge of the document saved on the
recipient's machine.
For a fax machine, the transmission speed refers to that of the fax modem.
In this function, the fax can be communicated at a high transmission speed of
33,600 bps. When overseas communication mode is set, it communicates at
a noise-resistant high transmission speed at 7,200 bps or 4,800 bps.
The time needed to send a fax. The higher the resolution or larger the paper,
the longer the transmission takes.
Abbreviation for Transmitting Subscriber Identification. ID of the fax transmis-
sion terminal.
This is a communication mode used at the time of fax communication of super
G3. There are cases when the communication is not possible in super G3
mode depending on the telephone line conditions when the recipient's ma-
chine/ own machine is connected to a telephone line via private branch ex-
change. In such cases, it is recommended to communicate with super G3
mode turned off by deselecting the V. 34.
This function first confirms the document size which cannot detect correct
document size due to folds, then scans and sends the document data after
verifying the correct document size. This function can be used only when the
document is scanned by ADF.
13
13-17