Troubleshooting - EcoQuest Flair Owner's Manual

Removing the Chassis & Changing the Fuse:
CAUTION: Unplug unit from AC outlet
A) Remove the chassis from the cabinet by
first removing the screw on the bottom
of the cabinet.
B) Slide the chassis out and place it
on its side.
C) The fuse holder is located on the right
front side of the circuit board.
D) Simply remove the fuse by gently
pulling it from the fuse holder.
E) Replace with a slow blow type fuse*.
F) Re-assemble in reverse order.
*100, 110 volt models - use 1.0 Amp slow blow fuse.
220/240 volt models - use 0.5 Amp slow blow fuse.

TROUBLESHOOTING

Indicators of Operation
Operation of the ion indicator lamps:
Turn the unit on and check that the small red/orange lamp is illuminated. The
lamp is located inside the unit and is viewed by looking into the unit through
the front grill. Illumination of the internal lamp verifies that the frequency type
ionizer and needlepoint ionizer are functioning properly. The lamp should stay
illuminated as long as the unit is turned on.
A
B
C
9