Synairg - EcoQuest Flair Owner's Manual

SYNAIRG

PURIFICATION
TM
PLATE INSTALLATION
The Flair utilizes two SynAirG
plates.
1. Remove (2) phillips-head screws.
(220/240 volt only)
2. Remove the rear lint screen.
3. Fully insert the SynAirG
(A & B) between the guides until they stop.
4. Re-install lint screen as shown below.
NOTE: The Flair's SynAirG
should only be used in the Flair system.
CAUTION: Do not operate unit without one or
both SynAirG purification plate(s) properly
TM
installed. Doing so may void your warranty.
LINT SCREEN INSTALLATION
1. Always install bottom of lint screen first.
2. The white lint screen tab should depress
the safety switch arm towards the
bottom of the unit.
Unit will not operate if safety switch is not
depressed.
3. Fit top of lint screen into cabinet.
4. Secure with (2) phillips-head screws.
(220/240 volt only)
1
purification
TM
purification plates
TM
purification plates
TM
2
2 Screws
(220 & 240 volt only)
Lint
Screen
Tab
3
a
b
5