Setting / Adjusting Controls - EcoQuest Flair Owner's Manual

SETTING AND ADJUSTING CONTROLS
1. FAN CONTROL
The disbursement of cleansing properties is best accomplished with good air
circulation. The fan control should be set as high as possible without creating an
undesirable noise level. This will be determined by personal preference and the
distance you wish the cleansing properties to be dispersed.
Note: A ceiling fan can also aid in distribution of cleansing properties.
2. OZONE CONTROL
Ozone Control: Set the control at the nine o'clock position for one hour. Adjust the
ozone control up or down after one hour based on the following criteria:
1. The numbers around the purifier control are square footage markings that
should be matched to the square footage of the environment. Under normal
conditions it is not necessary to turn the ozone control indicator above the
square footage of the environment.
2. Keeping in mind the previous statement (#1), adjust the purifier so the odor of
ozone fades into the background 15-30 seconds after entering the environment.
3. When the control is turned below the 100 square foot setting the ozone will be
turned completely off, the fan and ionization will continue to operate normally.
Note: Removing one plate allows more precise control in small areas or in lightly
polluted environments.
3. SANITIZING MODE
• Press sanitizing button to start or
stop.
• Unit will operate for two hours at
the maximum ozone output and
then return to the output that
matches the purifier setting.
• To interrupt sanitize mode before
the end of the two hour period,
turn the power off for 10 seconds
and then turn power back on.
Fan Control
Ozone Control
Sanitize
Mode
button
7