Seagull Models SUPER TUCANO Instruction Manual page 13

8) Reinstall the servo horn by sliding the
connector over the pushrod wire. Center the
throttle stick and trim and install the servo horn
perpendicular to the servo center line.
9) Move the throttle stick to the closed position
and move the carburetor to closed. Use a 2.5mm
hex wrench to tighten the screw that secures
the throttle pushrod wire. Make sure to use
threadlock on the screw so it does not vibrate
loose.
www.seagullmodels.com
gine and line up the back edge of the cowl with
the marks you made on the fuselage then trim
and cut as shown.
Because of the size of the cowl, it may be nec-
essary to use a needle valve extension for the
high speed needle valve. Make this out of suf-
ficient length 1.5mm wire and install it into the
end of the needle valve. Secure the wire in
place by tightening the set screw in the side of
the needle valve.
COWLING.
1) Slide the fiberglass cowl over the en-
Trim and cut.
Trim and cut.
Trim and cut.
13