Inserting/Exchanging Colours; Installing Top Hats - Robe Color Wash 575E AT User Manual

3 adjustment screws "A,B,C"

4.3 Inserting/Exchanging colours

DANGER!
Install the colours with the device switched off only.
Unplug from mains before!
If you wish to change colours ,open the top cover of the head by loosening 4 quarter-turn fasteners on the top
cover.
Gently bend out the colour module to release it from the 3 distance slots and eject it from the pressing snap.
Put the new colour module back under the pressing snap and push it to the distance slots.
colour-module
pressing snap

4.4 Installing top hats

The ColorWash 575E AT can be fitted with various types of the top hats-see chapter "Technical specifications".
If you wish to install a top hat (optional),follow the instructions:
Switch the device off before installing the top hat!
Installing the top hat on the front lens-holder of the fixture:
.Loosen 4 lens holder quarter-turn screws and hook both securing springs to the plastic projections in the front
lens-holder.Tighten the 4 lens holder quarter-turn screws again.
.Put desired top hat onto a front lens-holder and fasten it by two fastening screws.
3.Snap both springs to the slots in the top hat.
Fastening screw Top hat
Securing spring
Fastening screw
Slot
Securing spring
Plastic projection
7 Lens-holder