Error And Information Messages - Robe Color Wash 575E AT User Manual

2 ...Commands relative resetable values
Occured errors during fixture operation are signaled by warning icon on the display:
Press [ESC] to see the current error messages. Description of error messages:
Active Lamp Timer
This message appears if you try to switch on the lamp within 5 minutes after having switched it off (the lamp is
too hot). The message will appear on the display if the lamp doesn't ignite within 28 seconds. The ColorWash
575E AT will store this information and automatically ignite the lamp when the 5 minutes period has expired.
Caution: The message is disabled if the lamp light sensor (function "Lamp Sensor"in menu Personality) is
switched Off.
Lamp Error
The ignition of the lamp is seven times unsuccessful (the "Active Lamp Timer" message appeared six times
before), and the display shows "Lamp Error", meaning that the lamp could be damaged or even missed or
there could be a failure on the ignitor or ballast.
Please place or replace the lamp and contact your dealer if the situation was not caused by the lamp.
Caution: The message is disabled if the lamp light sensor (function "Lamp Sensor" in menu Personality) is
switched off.
Lamp Sensor Error
This message informs the lamp light sensor is failed.
Caution: The message is disabled if the lamp sensor (function Lamp Sensor in menu Personality) is switched
Off.
Overheated-Lamp Off
This message informs that the fixture head is overheated and the lamp was switched off by its head tempe-
rature sensor.
Short Power Error
This message will appear if the fixture was shortly disconnect from the main.
Supply Frequency Error
This message will appear if the frequency of the main is not standard 50 or 60 Hz.This message can appear as
a result of the interference during the lamp starting (if the lamp or igniter is old) or as a result of the interference
by neighbouring devices. In these cases the message does not affect the fixture operating!
Temper.Sensor Error
The message informs you that the communication betwen the head and the main board in the fixture base was
cut off (or the head temperature sensor is defective) and the lamp was automatically switched off.
Power down mode
This message will appear if the fixture is switched to the low power mode (e.g. fixture head is overheated).
The following error messages are separated into  groups:
xxxx xxxx Error 1 (e.g.Colour Wheel 1 Error 1 )
xxxx xxxx Error 2 (e.g.Colour Wheel 1 Error 2 )
There are some possible reasons of faults:
Message
xxxx xxxx Error 1
xxxx xxxx Error 1/xxxx xxxx Error 2 Magnetic sensor is permanently Off(e.g.leading wire is disconnected,
value PARAMETER_DATA=0x84 - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x88 - lamp OFF if DMX is not present

11. Error and information messages

Characteristic fault
Magnetic sensor is permanently On (e.g. leading wire is short-
circulated,defective stepping motor, defective control circuit on the
PCB)
defective magnetic sensor,missing magnet),defective stepping motor
30