4.6 Connection to the mains
Verify the power supply settings before applying power!
If you wish to change the power supply settings,see the chapter below.
Connect the fixture to the mains with the power cord.
If the plug on the flexible cord is not the right type for your socket outlets,do not use an adaptor,but remove the
plug from the cord and discard.Carefully prepare the end of the the supply cord and fit a suitable plug.
The earth has to be connected!
Cord plug connections:
Cable (EU)
Brown
Light blue
Yellow/Green
4.7 Changing the power supply settings
Electronic ballast
The operating range of the electronic ballast is 90 VAC-50 VAC,50-60Hz.The transformer has to be set to
the local AC voltage.
If you want to change the power supply settings,follow the instructions:
1.Disconnect the fixture from AC power.
.Remove the both top base covers by loosening the screws.
3.Move the wire (3) on the transformer connection block to the position according to the desired voltage.
5.Close the fixture base before applying AC power.
Do not connect the fixture to a dimmer system!
Cable (US)
Black
White
Green
Example:
Pin
International
Live
L
Neutral
N
Earth
9