Rdm - Robe Color Wash 575E AT User Manual

without taking it out from the case.To enter "Power down mode":
Press and hold [ENTER] and at the same time switch on the Power switch.The following message appears:
Press [ENTER] to activate "Power down mode" without fixture reset.Now you can set features and behaviour of
the fixture by using "Fixture Address"menu and "Personality" menu.It is expected,that this mode will be exited by
switching the fixture off ,but if you want to go directly to "normal operation mode",execute any fixture reset.
Note:All motors in "Power down mode" are deactivated and switching the lamp on from the control panel is
blocked.
This fixture supports an RDM operation. The RDM (Remote Device Management) is a bi-directional communica-
tions protocol for use in DMX5 control systems, it is the new open standard for DMX512 device configuration
and status monitoring.
The RDM protocol allows data packets to be inserted into a DMX5 data stream without adversely affecting
existing non-RDM equipment. By using a special „Start Code," and by complying with the timing specifications
for DMX5, the RDM protocol allows a console or dedicated RDM controller to send commands to and receive
messages from specific moving lights.
The ROBE DreamBox with an additional ROBE RDM-network software provides the RDM functionality. The
DreamBox supports RDM - new control protocol featuring AutoPatch and Fixture Status Monitoring.
The list of RDM commands for ColorWash 575E AT is the following:
Parameter ID
DISC_UNIQUE_BRANCH
DISC_MUTE
DISC_UN_MUTE
DEVICE_INFO
SUPPORTED_PARAMETERS
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
IDENTIFY_DEVICE
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SENSOR_DEFINITION
SENSOR_VALUE
DISPLAY_INVERT
DISPLAY_LEVEL
PAN_INVERT
TILT_INVERT
DEVICE_RESET
DMX_PERSONALITY
DMX_PERSONALITY_DESCRIPTION
STATUS_MESSAGES
STATUS_ID_DESCRIPTION
LAMP_STATE
LAMP_ON_MODE
1
DEVICE_HOURS
2
LAMP_HOURS
2
LAMP_STRIKES
2
1 ...Another options for this command (only for Robe´s fixtures):
Realy Skip Initial Reset?
Escape/Enter
Discovery command SET command

10. RDM

*
*
*
9
GET command
*
*
*
* *
* *
*
*
* *
*
*
* *
* *
* *
* *
*
* *
*
*
*
* *
* *
*
*
*