Ethernet / DMX operation
Options "Ethernet/DMX" has to be selected from "Set Ethernet Mode" menu on the first fixture (connected to
the network) in the fixture chain,next fixtures have standard DMX addresses.
Connect the Ethernet-input of the first fixture in the data chain with the network. Connect the DMX output of
this fixture with the input of the next fixture until all fixtures are connected to the DMX chain.
Caution: At the last fixture, the DMX chain has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a XLR-plug and connect it in the DMX-output of the last fixture.
Example:
DMX address=73
DMX address=217
DMX address=25
DMX address=25
4
(DMX address=1)
IP addres=002.168.002.002
Universe=0
(DMX address=1)
IP addres=002.168.002.003
Universe=1
Ω
resistor