Yamaha YZF-R6 Service Manual page 266

CARBURETORS
3. Install:
S pipes
S fuel feed pipes
S vacuum chamber pipe
S vacuum chamber air vent hose
S springs
S float chamber air vent hoses
S hose joint
S spacers
S copper washer
S connecting bolts
NOTE:
S Do not tighten the connecting bolts yet.
S Install the throttle valve lever 1 onto carbure-
tors #2, #3, and #4 between the spring 2 and
synchronizing screw 3 .
4. Install:
S starter plunger link 1
NOTE:
Install the starter plunger link 1 onto each start-
er plunger.
5. Tighten:
S connecting bolts
NOTE:
S Place the carburetor assembly on a surface
plate with the intake manifold side down.
Then, tighten the connecting bolts while push-
ing down the carburetor assembly with an
even force.
S After tightening the connecting bolts, check
that the throttle valve lever and starter plunger
link operate smoothly.
6. Install:
S starter cable 1
NOTE:
Install the starter cable holder 2 onto the start-
er cable.
6-10
CARB
7 Nm (0.7 mSkg)