Yamaha YZF-R6 Service Manual page 335

HANDLEBARS
4. Install:
S left handlebar switch 1
NOTE:
Align the projection a on the left handlebar
switch with the hole b in the left handlebar.
5. Install:
S handlebar grip
S grip end
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
6. Adjust:
S clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" in chapter 3.
Clutch cable free play (at the end
of the clutch lever)
10 X 15 mm
7. Adjust:
S throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" in chapter 3.
Throttle cable free play (at the
flange of the throttle grip)
6 X 8 mm
7-58
CHAS