STEERING HEAD
b. Remove the bearing race from the lower
bracket with a floor chisel 2 and hammer.
c. Install a new dust seal and new bearing
races.
CAUTION:
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
S Always replace the bearing balls and bearing
races as a set.
S Whenever the steering head is disassembled,
replace the dust seal.
4. Check:
S upper bracket
S lower bracket
(along with the steering stem)
Bends/cracks/damage ! Replace.
EAS00683
INSTALLING THE STEERING HEAD
1. Lubricate:
S upper bearing
S lower bearing
S bearing races
Recommended lubricant
Lithium soap base grease
2. Install:
S bearing
S bearing cover
S lower ring nut 1
S rubber washer 2
S upper ring nut 3
S lock washer 4
Refer to "CHECKING AND ADJUSTING
THE STEERING HEAD" in chapter 3.
7-62
CHAS