Getting Started With Switch Configuration
N o t e
By default, the switch is configured to acquire an IP address configuration
from a DHCP or Bootp server. To use DHCP/Bootp instead of the manual
method described in this chapter, see "DHCP/Bootp Operation" in the
Management and Configuration Guide which is on the ProCurve Web site.
See
Using the Switch Setup Screen
The quickest and easiest way to minimally configure the switch for manage-
ment and password protection in your network is to use a direct console
connection to the switch, start a console session, and access the Switch Setup
screen.
1.
2.
Figure 3-1. Switch Setup Screen
3-2
page 5-1
for details.
Using the method described in the preceding section, connect a terminal
device to the switch and display the switch console command (CLI)
prompt (the default display).
The CLI prompt appears displaying the switch model number, for
example:
ProCurve 5400zl#
At the prompt, enter the setup command to display the Switch Setup
screen. The following illustration is an example of a Setup screen with
default settings.
xl
ProCurve Switch 5406zl
ProCurve Switch 5406zl
T
imeP Mode [Disabled] : Disabled
xl
T
IMEP
5