HP 5400zl Series Installation And Getting Started Manual page 66

Getting Started With Switch Configuration
Configuring the ProCurve Wireless Edge Services zl Modules (J9051A, J9052A)
■
The following example enters the wireless-services context of a module
installed in Slot B of a zl switch and then displays the IP address assigned by
DHCP to the module:
If no DHCP service is available or if the administrator wishes to manually set
the Wireless Edge Services zl Module IP Address, it can be specified through
the CLI. From the wireless-services context, enter the config context and use
the interface vlan1 command to configure the vlan1 interface. Use the following
command to set the IP address:
ProCurve(wireless-services-<slot-id>)(config-if)# ip address <IP>
In the following example, the CLI commands set the module's IP address to
10.245.22.14 with a 21-bit subnet mask.
If necessary, use the following command from the wireless-services and config
contexts to set or change the default gateway:
ProCurve(wireless-services-B)(config)#ip default-gateway <ip-addr>
3-8
To display the module's IP address, enter:
ProCurve (wireless-services-id)# show ip interfaces
ProCurve# wireless-services b
ProCurve(wireless-services-B)#show ip interface
Interface IP-Address/Mask
vlan1 10.35.12.24(DHCP) up
ProCurve(wireless-services-B)#
where <slot-id> is the slot in the zl switch where the module is installed.
<IP> is the IP address in CIDR notation (/mask bit number), or
dhcp which will use DHCP to obtain an IP address.
ProCurve(wireless-services-B)#configure
ProCurve(wireless-services-B)(config)#interface vlan1
ProCurve(wireless-services-B)(config-if)#ip address 10.245.22.14/21
ProCurve(wireless-services-B)(config-if)#show ip interface
Interface IP-Address/Mask
vlan1 10.245.22.14/21
ProCurve(wireless-services-B)(config-if)#
where <ip-addr> is the numeric IP address of the default gateway, for
example 10.1.2.1.
Status Protocol
up
Status Protocol
up up