Ricoh C23535 Operating Instructions Manual page 1734

Monitoring and Configuring the Printer
Message
Login to fileserver <file server name>
(<IPX|IPv4|IPv6>,<NDS|BIND-
ERY|NDS|BINDERY>)
Memory allocate error.
Name registration success. WINS Serv-
2
er=<WINS server address> NetBIOS
Name=<NetBIOSname>
Name registration success in Broadcast
name=<NetBIOS Name>
Name registration failed. name=<NetBIOS
name>
nbtd start.
nprinter start (Netware)
nwstart start. (NetWare)
Open log file <file name>
phy release file open failed.
Print queue <print queue name> cannot be
serviced by printer 0, <print servername>
Print server <print servername>has no printer. (In the print server mode) The printer is not as-
print session full
Printer <printer name> has no queue
pserver start. (NetWare)
Required file server (<file servername>) not
found
received EAP Failure
restarted.
sap enable, saptype=<SAP type>, sap-
name=<SAP name>
server identity invalid
108
Problem and solutions
(In the print server mode) Login to the file
server is in the NDS or BINDERY mode.
Data cannot be obtained.
Disconnect the USB cable, and then connect it.
Name registration of <NetBIOS Name> to
<WINS serveraddress> was successful.
Name registration by Broadcast name of <Net-
BIOS Name>was successful.
Name registration of <NetBIOSName> failed.
Change to different NetBIOS name.
The nbtd service has started.
(In the remote printer mode) The NetWare
service has started.
The service for NetWare protocol stack setting
has started.
(In the print server mode)The specified log file
has been opened.
Replacing the network interface board is required.
Contact your sales or service representative.
(In the print server mode) The print queue
cannot be established. Make sure that print
queue exists on the specified file server.
signed to the print server. Using NWadmin,
assign the printer, and then restart it.
No more print jobs can be accepted.
(In the print server mode) The print queue is
not assigned to the printer. Using NWadmin,
assign the print queue to the printer, and then
restart it.
(In the print server mode) The NetWare serv-
ice has started.
The required file server is not found.
EAP reception failed.
The lpd service has started.
The SAP function has started.The SAP packet
is issued to advertise the service on the SAP ta-
ble on the NetWare server.
The server ID is disabled. Check the server au-
thentication.