Switches; Checking Switch Continuity - Yamaha TW200N Service Manual

"∞"
"Ω×1"
1
R Br/L L/Y L/B
ON
OFF
R Br/L
L/Y L/B

SWITCHES

SWITCHES
"0"

CHECKING SWITCH CONTINUITY

Check each switch for continuity with the
pocket tester. If the continuity reading is incor-
rect, check the wiring connections and if nec-
essary, replace the switch.
CAUTION:
Never insert the tester probes into the cou-
pler terminal slots 1. Always insert the
probes from the opposite end of the cou-
pler, taking care not to loosen or damage
the leads.
Pocket tester
NOTE:
• Before checking for continuity, set the pocket
tester to "0" and to the "Ω × 1" range.
• When checking for continuity, switch back
and forth between the switch positions a few
times.
The terminal
(e.g.,main switch, engine stop switch) are
shown in an illustration similar to the one on
the left.
The switch positions a are shown in the far
left column and the switch lead colors b are
shown in the top row in the switch illustration.
NOTE:
" " indicates a continuity of electricity
between switch terminals (i.e., a closed circuit
at the respective switch position).
The example illustration on the left shows
that:
There is continuity between red and brown/
blue, and between blue/yellow and blue/black
when the switch is set to "ON".
– 67 –
ELEC
YU-03112
connections for
– +
switches