Yamaha TW200N Service Manual page 67

FRONT BRAKE
3. Remove:
• retaining bolt (lower)
4. Install:
• brake pad springs
• brake pads
• brake caliper
5. Fill:
• Brake fluid reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended brake fluid
DOT4
WARNING
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir.Water
will significantly lower the boiling point of
the brake fluid and could cause vapor
lock.
CAUTION:
Brake fluid may damage painted surfaces
and plastic parts.Therefore, always clean
up any spilt brake fluid immediately.
6. Bleed:
• brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM".
– 60 –
CHAS
27 Nm (2.7 m · kg, 19 ft · lb)