Yamaha TW200N Service Manual page 22

1 Diode
2 Battery positive lead
3 Starter relay
4 Starter motor lead
5 CDI unit
6 Wire harness
7 Turn signal relay
È Fasten the wire harness with a plastic locking tie at the section just before the
leads split.
É Pass the battery breather hose inside the battery positive lead.
Ê Pass the rear brake light switch lead in front of the frame so that it is not
squeezed by the side cover and frame.
Ë Fasten the rear brake light switch lead and turn signal relay lead with a plastic
locking tie.
Ì Face the rear brake light switch lead to the rear of the frame.
Í Pass the battery breather hose through the hose guide.
Î Pass the battery breather hose through the hole in the electrical components box.
Ï Fasten the wire harness and diode with a plastic locking tie.
– 15 –
CABLE ROUTING
SPEC