Installer And Service Menu (I/S); How To Use The Control Panel - Bosch EHP 6-11 LW User And Installation Manual

Installer and service menu (I/S)

As the installer you have your own section of menus for settings, e.g. for
commissioning. These are accessed from the control panel by holding
down the menu button for approximately ten seconds.
The menu displays are divided into lines and each display has a number to
make it easy to fi nd. If there is no activity for 30 minutes the menu display
automatically returns to Customer level 1.
The Installer level also includes Customer levels 1 and 2.

How to use the control panel

Here follows an example of how to use the control panel. The example shows how
you move to menu display 5.13 and confi rm the external sensors. You will also fi nd
more information about the control panel under the heading Control Panel in the
User section.
1. Press the menu button for approximately ten seconds until Access = SERVICE
is shown on the menu display. Now press the Menu button.
2. The menu display Indoor temperature settings (menu 1) is shown.
3. Turn the menu dial clockwise (to the right) until you access the menu
Commiss./Service for installer (menu 5). Now press the Select button.
4. Turn the menu dial clockwise until you reach the menu Connected extra sensor
in op. (menu 5.13). Now press the Select button.
5. The menu display Extra sensor(s) is shown. Confi rm the extra sensors that you
have connected by pressing the Confi rm button.
6. The text Confi rming... is briefl y shown in the menu display. This means your
setting is being registered in the heat pump.
7. When the setting has been registered the previous menu display is shown.
Press the Return button twice to return to the main menu.
The Installer and service menu (I/S)
is only for installers. Under no circum-
stances may the user access this level.
65
Commissioning the heat pump
Warning
Reg 637 I/S
040622 16:08:15 Tu
temp. Info Menu
(10 sec)
Main menu
Indoor temperature
settings 1
Return Select
Main menu
Commiss./Service
for installers 5
Return Select
Commiss./Service
Connected extra
sensor in op 5.13
Return Select
Extra sensor(s)
GT4 GT5
Return Confi rm
Extra sensor(s)
Confi rming...
Extra sensor(s)
GT4 GT5
Return Confi rm