Cpe Management - Draytek Vigor2860 Series User Manual

Username
Password
Polling Interval
WAN IP for Remote
Connection
VPN Settings
IPsec Mode
Security Method
Encryption Type
Local Subnet
After finishing all the settings here, please click OK to save the configuration.
3 . 1 3 . 2 C P E M a n a
3 . 1 3 . 2 C P E M a n a
All the CPEs managed by Vigor2860 series can be seen with icons from this page
Before using such feature, make sure the CVM port has been enabled and configured properly.
For detailed information, return to section 3.12.1.
3 . 1 3 . 2 . 1 M
3 . 1 3 . 2 . 1 M
This page allows you to manage the CPEs connected to Vigor2860 series.

Page without CPE connected
Type the port number in the box.
Type a username which will be used by any CPE tried to
connect to Vigor router.
Type the password for the user.
Type the time value (unit is second). The range is from 60 ~
86400.
For Vigor router can managed only the client from WAN
interface, therefore you have to specify which interface will be
used for such function. If you choose MANUALLY, you have
to specify WAN IP address.
Choose Aggressive or Main as the IPsec Mode.
Choose one of the following methods (AH or ESP) for the
security of data transmission. For example, choose AH to
specify the IPsec protocol for the Authentication Header
protocol. The data will be authenticated but not be encrypted.
Choose one of the selections as the encryption type.
Type the IP address and subnet mask of local host.
g e m e n t
g e m e n t
a n a g e d D e v i c e L i s
a n a g e d D e v i c e L i s
t
t
295
Vigor2860 Series User's Guide