For Vigor2860Vn-Plus - Draytek Vigor2860 Series User Manual

1 . 2 . 4 F o r V i g o r 2 8
1 . 2 . 4 F o r V i g o r 2 8
LED
ACT (Activity)
USB
2.4G
WAN2
DSL
5G
Line
Phone (1-2)
LED on Connector
Left
WAN2
LED
(Giga)
Right
LED
Left
GigaLAN
LED
1~6
Right
6 0 V n - p l u s
6 0 V n - p l u s
Status
Blinking
Off
On
Blinking
On
Blinking
On
Off
Blinking
On
Blinking
On
Blinking
On
Off
On
Off
Blinking
On
Off
Blinking
On
Off
On
Off
Blinking
On
Explanation
The router is powered on and running normally.
The router is powered off.
USB device is connected and ready for use.
The data is transmitting.
Wireless access point with bandwidth of 2.4GHz is
ready.
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will return
to normal condition after two minutes. (You need to
setup WPS within 2 minutes.)
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
The router is ready to access Internet through DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
Wireless access point with bandwidth of 5GHz is
ready.
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will return
to normal condition after two minutes. (You need to
setup WPS within 2 minutes.)
A PSTN phone call comes (in and out). However,
when the phone call is disconnected, the LED will be
off.
There is no PSTN phone call.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
9
Vigor2860 Series User's Guide