Draytek Vigor2860 Series User Manual page 113

General Settings
ATM OoS
Open Port-based Bridge
Connection for this
Channel
interface the channel shall use here.
VPI - Type in the value provided by your ISP.
VCI - Type in the value provided by your ISP.
Protocol - Select a proper protocol for this channel.
Encapsulation - Choose a proper type for this channel. The
types will be different according to the protocol setting that
you choose.
Add VLAN Header – Check the box to enable the
following two options.
VLAN Tag – Type the value as the VLAN ID number.
Valid settings are in the range from 1 to 4095. The network
traffic flowing on each channel will be identified by the
system via their VLAN Tags. Channels using the same
WAN type may not configure the same VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
QoS Type - Select a proper QoS type for the channel.
Type the values for PCR, SCR and MBS respectively.
The settings here will create a bridge between the LAN
ports selected and the WAN. The WAN interface of the
bridge connection will be built upon the WAN type selected
using the VLAN tag configured.
Service Type - Normally, service type is used for the
service of video stream (e.g., IPTV). It can divide the
packets from remote control and from video stream into
different PVC. Such feature is used for specific application.
Please choose Normal as the Service Type.

Normal – It means that the PVC can accept all
packets.

IGMP –It means that such PVC can accept IGMP
packets only. Such type just meets a specific
103
Vigor2860 Series User's Guide