Centre-Stand - PIAGGIO Beverly 250 USA Workshop Manual

Suspensions
- Support the muffler support bracket sufficiently
- Using the special punch, remove the bearing
from its seat as shown in the photograph
Specific tooling
020376Y Adaptor handle
020456Y Ø 24 mm adaptor
- Heat the bearing seat using the heat gun
- Using the special punch, install a new bearing in
the seat as shown in the photograph
Specific tooling
020376Y Adaptor handle
020151Y Air heater
Refitting
To refit, carry out the removal operations in reverse order, observing the prescribed tightening torques.
Locking torques (N*m)
Rear wheel axle nut 104 ÷ 126 Muffler support arm to engine screws (*) 20 ÷ 25 Shock absorber
lower clamp 33 ÷ 41

Centre-stand

- Remove the two return springs from the centre
stand. - Undo the nut shown in the figure. - Re-
move the bolt from the right side. - Remove the
centre stand. - On refitting tighten the nut to the
prescribed torque.
Locking torques (N*m)
Centre stand bolt 25 ÷ 30
SUSP - 22
Beverly 250 USA