Helmet Bay; Fuel Tank - PIAGGIO Beverly 250 USA Workshop Manual

Chassis

Helmet bay

- Remove the canister cover from inside the helmet
compartment and hence remove all of its compo-
nents (see the "Maintenance - Anti-evaporative
System - Components Removal" chapter).
- Rimuovere il coperchio dell'impianto Canister
all'interno del vano portacasco quindi - Remove
the side panels.
- Detach the electrical connectors.
- Unscrew the eight fixing screws, four of which
located inside the helmet compartment.
- Remove the number-plate holder tail after un-
screwing the four fixing screws shown in the figure
and disconnecting the wiring.
- Remove the helmet compartment.
See also
Removing system components

Fuel tank

- Remove the knee-guard.
- Remove the front wheel housing.
- Remove the footrest.
- Remove the roll-over valve breather tube.
N.B.
THIS OPERATION SHOULD PREFERABLY BE
PERFORMED WITH THE TANK EMPTY.
- Separate the electrical connections of the fuel
gauge and disconnect the fuel supply line and tank
breather;
- Undo and remove the screw fixing the horn
shown in the upper figure after disconnecting the
electrical connection;
- Remove the toggle handles by loosening the 4
retaining screws;
- Remove the support bracket by loosening the 2
retaining screws of the bracket at the frame;
CHAS - 10
Beverly 250 USA