Automatic Transmission; Transmission Cover; Air Duct - PIAGGIO Beverly 250 USA Workshop Manual

Engine

Automatic transmission

Transmission cover

- To remove the transmission cover it is necessary
to remove the plastic cover first, by inserting a
screwdriver in the slotted holes. Using the clutch
bell lock wrench shown in the figure, remove the
driven pulley shaft locking nut and washer.
Specific tooling
020423Y driven pulley lock wrench
- Remove the cap/dipstick from the engine oil filling
hole.
- Remove the ten screws.
- Remove the transmission cover.
If this operation is carried out directly on the vehi-
cle, remove the cooling air supply coupling of the
transmission housing.

Air duct

- Remove the transmission compartment air intake
cover shown in the photograph.
ENG - 2
Beverly 250 USA