Removing The Ignition Key-Switch When On *Lock*; Front Wheel Housing; Taillight Assy - PIAGGIO Beverly 250 USA Workshop Manual

Beverly 250 USA

Removing the ignition key-switch when on *lock*

In position "Lock", it is not possible to access the
cylinder retaining spring. The spring must then be
removed as shown in the figure, allowing the lock
spring to be pressed out.
N.B.
TO REFIT THIS ITEM, THE SCOOTER STEER-
ING LOCK MUST BE RELEASED WITH THE
LOCK BODY (INTERNAL AND EXTERNAL
PART) IN POSITION "OFF". PROCEED AS DE-
SCRIBED IN THE PREVIOUS PARAGRAPH.
See also
Removing the ignition key-switch when on *off*

Front wheel housing

- Remove the shield back plate.
- Remove the footrests.
- Remove the front suspension.
- Loosen the remaining retaining screws holding
the central chassis cover.
- Remove the radiator cover.
See also
Removing the front wheel
Footrest
Knee-guard

Taillight assy.

- Remove the cover of the luggage rack (snapped-
in).
- Remove the side bumpers.
- Unscrew the 3 screws holding the rear light.
- Remove the rear light assembly after disconnect-
ing the electrical cable harness.
See also
Side fairings
Chassis
CHAS - 7