Characteristics
Name
Internal engine crankcase bulkhead (transmis-
sion-side half shaft) screws
Engine-crankcase coupling screws
Starter motor screws
Crankcase timing system cover screws (°)
Name
Water pump rotor cover
Screws for water pump rotor driving link
Thermostat cover screws
Bleed screw:
(°) Apply LOCTITE 242 medium-strength threadlock
(*) The two screws must be tightened to the prescribed torque after having done so with the rear wheel
axle nut. Safety locks: see "Pre-delivery operations".
(^) Fasten the nuts in two crossed passes.
(1) Before fitting the nuts lubricate them with engine oil
Overhaul data
Assembly clearances
Cylinder - piston assy.
CHAR - 10
CRANKCASE AND CRANKSHAFT
COOLING
Beverly 250 USA
Torque in Nm
4 ÷ 6
11 ÷ 13
11 ÷ 13
3.5 ÷ 4.5
Torque in Nm
3 ÷ 4
3 ÷ 4
3 ÷ 4
3