Listening To External Equipment - JVC 0803AIMMDWJEM Instructions Manual

Listening to External Equipment

Listening to External Equipment
You can listen to external equipment connected to the AUX/
DVD jacks on the rear of the unit.
• First make sure that the external equipment is properly
connected as follows (see also "Connecting External
Equipment" on page 8):
DO NOT connect other equipment while the power
is on.
To AUX/DVD jacks
To audio output
1
On the remote control:
Press FM/AM/AUX repeatedly
until "AUX" appears on the
display.
• Each time you press the button, the source
changes as follows:
FM
On the unit:
Press AUX/DVD.
• "AUX" appears on the display.
2
Turn down the volume level to "VOLUME 0."
VOLUME
(On the remote control)
3
Start playing the external equipment.
• For operation of the external equipment, refer to the
manuals supplied with it.
27
AUX/DVD
RIGHT LEFT
External
equipment
FM/AM
/AUX
AM AUX
AUX/DVD
FM/AM
VOLUME
+
–
(On the unit)
4
Adjust the volume level to your desired
listening level.
5
Apply sound effects, if you wish.
• For how to apply sound effects, see pages 11 and 12.
To adjust the Audio Input Level
If the sound from the component connected to the
AUX/DVD jacks is too loud or is not loud enough when
changing from another source to "AUX," you can change the
audio input level through the AUX/DVD jacks (without
changing the volume level).
On the remote control ONLY:
Press and hold SET for more than 2 seconds
while the source is "AUX."
• Each time you press and hold the button,
the audio input level alternates between
"LEVEL 1" and "LEVEL 2."
LEVEL 1: Select this when the sound is too loud (initial
setting).
LEVEL 2: Select this when the sound is not loud enough.
To change the information shown on the display
On the remote control ONLY:
Press DISP/CHARA.
Each time you press the button, the
information on the display alternates between
the source indication and the clock indication.
• If an MD is inserted, the MD remaining recording time
("REC REMAIN") is shown before the clock indication.
SET
DISP/CHARA