Adding A Track To A Group-Entry Gr - JVC 0803AIMMDWJEM Instructions Manual

Adding a Track to a Group—ENTRY GR
This function allows you to enter a track into a group. The
track will be added as the last track in the selected group.
The track numbers will be renumbered.
• To stop any time during the editing process below before
step 8 , press GROUP TITLE/EDIT.
1
Insert an MD you want to edit into the MD
loading slot.
On the remote control ONLY:
2
Press GROUP TITLE/EDIT
repeatedly until "ENTRY GR ?"
appears on the display.
• If you want to stop this editing process, press CANCEL.
3
Press SET.
• During playback:
The currently playing track number starts flashing.
4
Press ¢ or 4 to select
the track.
• You can also select the track using
the number buttons. In this case,
the selected track starts playback repeatedly.
Ex.: When track 13 is selected.
5
Press SET.
• If the loaded MD has no group, you cannot go to the
• When the selected track belongs to a group, its group
• To cancel the setting, press CANCEL, then repeat from
6
Press GROUP SKIP ¢ or GROUP SKIP
GROUP TITLE
4 while holding SHIFT to select the group.
/EDIT
SET
7
Press SET.
• To cancel the setting, press CANCEL, then repeat from
GROUP SKIP GROUP SKIP
8
Press ENTER.
"EDITING" appears on the display. Then
"WRITING" and the REC (MD recording)
indicator flash while the editing you have
made is being recorded on the MD and playback stops.
You are trying to enter the selected track into the same group again. Repeat
procedure from step 6 .
following steps.
number appears on the display.
step 4 .
SHIFT
Ex.: When group 18 is selected.
step 4 .
When "CANNOT ENTRY!" appears on the display in
step 7
Continued
SET
GROUP SKIP GROUP SKIP
SET
ENTER
40