Using The Dvd Multi Playback Mode; Activating The Dvd Multi Playback Mode - JVC RX-8040B Instructions Manual

Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD
player.
• The following operations are only possible when the receiver is ready for Zone 1 operations, and are used only
for Zone 1 sources.
Connection diagram
AUDIO
LEFT
SUBWOOFER CENTER RIGHT
DVD
IN
SURR
R
L
R
L
DVD player
DVD
A
B
C
D
E
Å To component video output
ı To subwoofer output
Ç To center channel audio output
Î To S-video output
‰ To composite video output
Ï To left/right front channel audio output
Ì To left/right surround channel audio output
Note:
When connecting a DVD player to the component video input
jacks, make the component video input setting (VIDEO IN DVD)
correctly. See page 38 for details.

Activating the DVD MULTI Playback Mode

DVD MULTI playback mode is the best connection method for
enjoying DVD Audio sounds.
• When a DVD Audio disc is played back, the original high-
quality sounds can be reproduced only using this mode.
50
COMPONENT VIDEO
DVD
IN
VIDEO
VIDEO S-VIDEO
DVD
IN
FRONT
F G
IMPORTANT:
Check the following before or while using the buttons and controls.
For Zone 1 operations:
The ZONE 1 indicator lights up on the unit's display.
• When using the unit:
– "ZONE2" is not shown in the unit's main display.
• When using the remote control:
– Set the ZONE 1/ZONE 2 selector to ZONE 1.
– Check the indication shown on the remote's display when you
press a button—this indicates the remote control operation mode
together with multi-room operation mode (either for ZONE 1 or
ZONE 2) for about two hours.
ZONE 1 ZONE 2
Ex. When you press DVD MULTI with ZONE 1/ZONE 2
selector set to ZONE 1.
1. Press DVD MULTI so that "DVD" appears on the
display.
The MULTI indicator also lights up.
ANALOG MULTI
L C R LINEAR PCM
SUBWFR LFE
LS RS
Note:
When you select DVD MULTI as the source to play, the Surround
and DSP modes are canceled, and the SURROUND and DSP
buttons do not work.
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer also to the manual supplied with the DVD player.
You can adjust equalization patterns and speaker output levels.
See "Adjusting the equalization patterns" on page 40 for details.
Notes:
• When activating Zone 2 speakers, you cannot use the DVD MULTI
playback mode.
• Midnight Mode is not available for DVD MULTI playback mode (see
page 23).
• When using a headphones, you can listen to the front channels (left
and right) only. 3D Headphone (3D H PHONE) mode is not valid for
DVD MULTI playback mode.
AUDIO POWER
STANDBY ON
ZONE 2
ZONE 1
ZONE 1 ZONE 2 TV/CATV/DBS DVD
ON/OFF ON/OFF POWER POWER
ZONE 1
SPEAKERS 1
VOLUME
ZONE 1