Changing The Source Name; Reinforcing The Bass; Muting The Zone 1 Sound; Changing The Display Brightness - JVC RX-8040B Instructions Manual

Changing the Source Name

When you have connected an MD recorder to the TAPE/MD IN
jacks or a DBS tuner to the TV SOUND/DBS IN jacks on the rear
panel, change the source name which will appear on the display.
When changing the source name from "TV" to "DBS":
1. Press TV SOUND/DBS.
• Make sure "TV" appears on the display.
2. Press and hold TV SOUND/DBS until "ASSGN DBS"
appears on the display.
ANALOG
L R
LINEAR PCM
Note:
When connecting a DBS tuner to the TV SOUND/DBS IN jacks,
change the source name to "DBS," which will appear on the display
when selected as the source. Otherwise you cannot view any picture
from DBS tuner.
When changing the source name from "TAPE" to "MD":
1. Press TAPE/MD.
• Make sure "TAPE" appears on the display.
2. Press and hold TAPE/MD until "ASSGN MD" appears on
the display.
To change the source name to "TV" and "TAPE," repeat the
same procedure above.
• While selecting "DBS" as the Zone 2 source, you cannot change
the source name to "TV."
Notes:
• Once you change the source name, it is applied both for the Zone 1
and Zone 2 sources.
• Without changing the source name, you can still use the connected
components. However, there may be some inconvenience.
– "TAPE" or "TV" will appear on the display when you select the MD
recorder or DBS tuner.
– You cannot use the digital input (see page 22) for the MD
recorder.
– You cannot use the COMPU LINK remote control system (see
page 51) to operate the MD recorder.
24
Remote
The following basic operations are possible only using the
NOT
remote control.
Reinforcing the
Bass
Using the Sleep
Timer

Reinforcing the Bass

SPEAKERS 1
VOLUME You can boost the bass level.
ZONE 1
• Once you have made an adjustment, it is memorized for each
source.
Press BASS BOOST to boost the bass level.
The B. BOOST indicator lights up on the unit's display.
• Each time you press the button, Bass Boost turns on ("BOOST
ON") and off ("BOOST OFF") alternately.
Notes:
• This function affects only the sounds from the front speakers,
center speaker, and subwoofer.
• When Analog Direct is in use (see page 23), the Bass Boost is
canceled temporarily.

Muting the Zone 1 Sound

Press MUTING to mute the sound through all speakers in
Zone 1 and headphones connected.
"MUTING" appears on the unit's display and the volume turns off
(the VOLUME level indicator goes off).
To restore the sound, press MUTING again so that the VOLUME
level indicator and "MUTING OFF" appear on the unit's display.
• Turning MASTER VOLUME on the unit or pressing
VOLUME +/– on the remote control also restores the sound.

Changing the Display Brightness

You can dim the unit's display.
Press DIMMER.
• Each time you press the button, the brightness level of the unit's
display changes as follows:
BASS BOOST
SLEEP DIMMER
MUTING
Dimmer Much dimmer
Canceled
(Normal display)
Changing
the Display
Brightness
Muting the Sound