Basic Procedure; Adjusting The Equalization Patterns; Adjusting The Speaker Output Levels - JVC RX-8040B Instructions Manual

Basic Procedure

Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
Ex. When adjusting the subwoofer level to "–3."
1. Press ADJUST.
The last selected item appears on the display.
ANALOG
L R LINEAR PCM
SUBWFR
2. Turn MULTI JOG until an item you want
appears on the display.
• In this example, select "SUBWFR LVL." For available items,
see the list "Basic Adjustment Items" on page 39.
ANALOG
L R LINEAR PCM
SUBWFR
3. Press in MULTI JOG (PUSH SET).
The current setting (or level) for the selected item appears on the
display.
ANALOG
L R LINEAR PCM
SUBWFR
4. Turn MULTI JOG to select a setting you want or
to make an adjustment as you like.
ANALOG
L R
LINEAR PCM
SUBWFR
5. Press in MULTI JOG (PUSH SET).
6. Repeat steps 2 to 5 to set other items if necessary.
7. Press EXIT.
The source indication resumes on the display.
40

Adjusting the equalization patterns

You can adjust the equalization patterns to your preference.
• Once you have made an adjustment, it is memorized for each
source.
• The equalization pattern affects the front speaker sounds only.
7 Equalization adjustment—EQ 63Hz, EQ250Hz,
EQ 1kHz, EQ 4kHz, EQ16kHz
You can adjust five frequencies (63 Hz, 250 Hz, 1 kHz, 4 kHz,
16 kHz) within the range of –8 dB to +8 dB ("0 (dB)" is the
initial setting) in 2 dB steps.
• When an adjustment is made, the D.EQ indicator lights up on
the display.
To flat the equalization pattern, set all the frequencies to
"0 (dB)" in step 4 of "Basic Procedure" on the left column.
The D.EQ indicator goes off from the display.
Note:
When Analog Direct is in use, Equalization patterns are not
available.
SPEAKERS 1
VOLUME
ZONE 1

Adjusting the speaker output levels

You can adjust the speaker output levels.
• Once you have made an adjustment, it is memorized for each
source.
7 Adjustable speakers
You can adjust the following speakers' output levels within the
range of –10 dB to +10 dB ("0 (dB)" is the initial setting):
SPEAKERS 1
VOLUME
SUBWFR LVL
ZONE 1
FRNT L LVL
FRNT R LVL
CENTER LVL
SPEAKERS 1
VOLUME
ZONE 1
SURR L LVL
SURR R LVL
SBACK LVL
SPEAKERS 1
VOLUME
ZONE 1
Notes:
• If you have selected "NO" or "NONE" for a speaker (see page
34), the output level for the corresponding speaker is not
adjustable.
• Speaker output levels (except the subwoofer output level) are
not adjustable when Analog Direct is in use. But when you
canceled the subwoofer output using the SUBWOOFER OUT
ON/OFF button (see page 22), you also cannot adjust the
subwoofer output level.
Select to adjust the subwoofer output level.
Select to adjust the left front speaker output
level.
Select to adjust the right front speaker output
level.
Select to adjust the center speaker output
level.
Select to adjust the left surround speaker
output level.
Select to adjust the right surround speaker
output level.
Select to adjust the surround back speaker
output level.