Using The Dvd Multi Playback Mode; Activating The Dvd Multi Playback Mode - JVC RX-7000RBK Service Manual

Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD
player. Before playing back a DVD, refer also to the manual supplied with the DVD player.
IMPORTANT:
When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate this receiver, set it to "AUDIO/TV/
VCR".

Activating the DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back
a DVD using the analog discrete output mode on the DVD player.
Once you have made adjustments, the receiver memorizes the
adjustments until you change them. You also need to set the DVD
player to the analog discrete output mode.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel:
1. Turn SOURCE SELECTOR until
"DVD MULTI" appears on the
display.
Note:
When you select "DVD MULTI" as the source to play, the DSP
mode is canceled temporarily, and the SURROUND ON/OFF and
DSP MODE buttons do not work.
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the following
steps.
3. Adjust the speaker output levels.
1) Press (BALANCE/) SURROUND
ADJUST repeatedly until one of the
indications appears on the display.
"CENTER LEVEL":
To adjust the center speaker level.
"REAR L LEVEL":
To adjust the left rear speaker level.
"REAR R LEVEL":
To adjust the right rear speaker level.
2) Turn MULTI JOG to adjust the
selected speaker output level (from –10
dB to +10 dB).
3) Repeat 1) and 2) to adjust the other
speaker output levels.
33
From the remote control:
1. Press DVD MULTI so that "DVD
MULTI" appears on the display.
AUDIO/
TV/VCR
Note:
CATV/DBS
When you select "DVD MULTI" as the source to play, the DSP
mode is canceled temporarily, and the SURROUND ON/OFF and
SURROUND MODE buttons do not work.
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the following
steps.
3. Press SOUND.
The 10 keys are activated for adjusting the sound.
4. Adjust the speaker output levels.
• To adjust the center speaker level, press CENTER –/+ (from
SOURCE SELECTOR
–10 dB to +10 dB).
• To adjust the left rear speaker level, press REAR•L –/+ (from
–10 dB to +10 dB).
• To adjust the right rear speaker level, press REAR•R –/+ (from
–10 dB to +10 dB).
2
BALANCE/SURROUND
ADJUST
MULTI JOG
REAR•L
CENTER
5
3
ENTER
MENU MENU
DVD MUILTI
SOUND
REAR•R
6
8 9