JVC RX-8040B Instructions Manual page 124

Automatic Power On/Off (Standby)—only possible
with the COMPU LINK-3 and COMPU LINK-4
The CD player, CD recorder, and Cassette deck (or MD recorder)
turn on and off along with the receiver.
Automatic Power On:
• When you turn on the receiver by pressing
on the unit, or AUDIO POWER ON on the remote control
with ZONE 1/ZONE 2 selector set to ZONE 1:
When you turn on the Zone 1 sound by pressing
ZONE 1 ON/OFF while the receiver is turned on:
\ The ZONE 1 indicator lights up, and the source name for
Zone 1 appears on the unit's display, and one of the
connected components will turn on automatically, depending
on which component has been previously selected as the
Zone 1 source.
• When you turn on the receiver by pressing
AUDIO POWER ON on the remote control with
ZONE 1/ZONE 2 selector set to ZONE 2:
When you turn on the Zone 2 sound by pressing
ZONE 2 ON/OFF while the receiver is turned on:
\ The ZONE 2 indicator lights up on the display and one of the
connected components will turn on automatically, depending
on which component has been previously selected as the
Zone 2 source.
Automatic Power Off (Standby):
• When you turn off the receiver by pressing
on the unit or AUDIO POWER STANDBY on the remote
control, the connected components will turn off (standby).
• When you turn off the Zone 1 sound by pressing
ZONE 1 ON/OFF, the selected Zone 1 source component turns
off (unless the same component is selected as the Zone 2 source).
– If the ZONE 2 indicator is lit, the Zone 1 source will stop
playing, but will not turn off.
• When you turn off the Zone 2 sound by pressing
ZONE 2 ON/OFF, the selected Zone 2 source component turns
off (unless the same component is selected as the Zone 1 source).
– If the ZONE 1 indicator is lit, the Zone 2 source will stop
playing, but will not turn off.
52
STANDBY/ON
OR
OR
STANDBY/ON
Synchronized Recording (Only for Zone 1 Operations)
This operation is only possible when the receiver is ready for
Zone 1 operations.
Synchronized recording means the cassette deck (or MD recorder)
starts recording as soon as a CD begins playing.
To use synchronized recording, follow these steps:
1. Put a tape in the cassette deck (or an MD in the
MD recorder), and a disc in the CD player.
2. Press the record (¶) button and the pause (8)
button on the cassette deck (or on the MD
recorder) at the same time.
This puts the cassette deck (or MD recorder) into recording
pause.
If you do not press the record (¶) button and pause (8) button at
the same time, the synchronized recording feature will not
operate.
3. Press the play (3) button on the CD player.
The Zone 1 source changes on the receiver, and as soon as play
starts, the cassette deck (or MD recorder) starts recording. When
play ends, the cassette deck (or MD recorder) enters recording
pause, and stops about 4 seconds later.
Notes:
• During synchronized recording;
– The selected Zone 1 source cannot be changed. (You can
change the Zone 2 source.)
– If the same source is selected both for Zone 1 and Zone 2,
operating the Zone 2 source will affect the recording.
• The COMPU LINK remote control system may not operate properly
during synchronized recording;
– If the power of any playing or recording component is shut off.
– If the Zone 1 sound is turned off by pressing ZONE 1 ON/OFF.
In this case, you must start recording again from the beginning.
• You cannot use the CD recorder for synchronized recording.