Blower Operation - Jøtul GF 400 BV Sebago Installation And Operation Instructions Manual

Figure 35. Attach Blower to the Mounting
Bracket with the wing screw and connect
wires to Snapstat and female control
quick-connect.
Blower Operation
The optional variable-speed blower will enhance heat
circulation around the firebox and out into the room. The
blower is controlled by a heat activated switch (snap-
stat) that will ONLY function when the control switch
is in AUTO setting. After the fire has been burning for a
time, the snapstat will react to the heat and activate the
blower. Fan speed may be manually adjusted with the
rheostat knob. If the burner turns off, the blower will be
shut off automatically when the stove cools down.
If automatic blower circulation is not desired, place
the blower control switch in the MANUAL position.
Speed Control
Figure 36. Blower Controls
B U R N E R
Manual or
Automatic
Modes
Wing screw
G
W
W
G
BL
BK
POWER
GY
SNAPSTAT
SUPPLY
P P
P
BL GY BR
AUTO OFF MANUAL
Figure 37. Blower Wiring Diagram
CAUTION:
LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN
SERVICING CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION. VERIFY OP-
ERATION AFTER SERVICING.
ATTENTION:
AU MOMENT DE L'ENTRENTIEN DES COMMANDES,
ETIQUIETEZ TOUS LE FILS AVANT LE DEBRANCHEMENT.
ES ERREURS DE CEBLAGE PEUVENT ENTRA TUN FONC-
TIONNEMENT INADEQUAT ET DANGEREUX.
138301_Rev_G 10.4.11
Snapstat
Connectors
Male Quickconnector
to Female Quick-
connector
BLOWER
BK
BK BK
P
BK BK BK
P
RHEOSTAT
BR
P = QuickConnector Pin
SWITCH
21