Lights - Permobil K450 Service Manual

Lights

Lights
(accessories)
Removing the front lights
1. Switch off the main power switch on the
control panel.
2. Remove the battery on the relevant side of the
chassis, see page 7.
3. Unplug the light's cable at the contact on the
cable, which is above the battery. See
illustration.
4. Loosen the cable from the cable brackets in
the chassis. Note the cabling layout for
subsequent fitting.
5. Remove the two screws that hold each of the
lights in place. These are on top of the link
arm. See illustration.
6. Lift the light straight up and pull the cable from
the link arm.
NOTE
Fitting a new light on the same link arm is made easier if a
piece of string is tied to the cable at its contact before
removal. The string is then pulled through the link arm when
removing the light. Then tie the string to the new light's cable
and pull the cable through the link arm using the string.
Fitting
Fit in the reverse order.
The contact on the front light's cable.
The front lights are fixed in place
with two screws on each link arm.
Removing/fitting the front light.
44