Permobil K450 Service Manual page 41

General Module
The seat's actuators are all controlled via their own
General Module. These are held in place with two
nuts each on the rear of the chassis.
Removal
1. Switch off the main power switch on the
control panel.
2. Switch the main fuse to "OFF". See illustration.
3. Remove the chassis cover. See page 10.
4. Remove the General Module in question. It is
held in place with two nuts on the left side (see
illustration). Removing nos. 2 and 3 is easier if
the contact blocks are removed. These are
held in place with two nuts each. See
illustration below.
5. Remove the actuator's cable from the General
Module in question.
6. Remove the General Module's cable from the
contact block.
Fitting
Fit in the reverse order.
The contact blocks are fixed in place
with two nuts each.
Main fuse/battery isolator (On/Off)
1. General Module for "Seat angle".
2. General Module for "Seat-to-floor function".
3. General Module for "Seat lift".
General Module
41
General module
On
Off
1
2
3