Magnetic Brake - Permobil K450 Service Manual

Magnetic brake

Magnetic brake
Removal
1. Place the wheelchair on a level surface.
2. Switch off the main power switch on the
control panel.
3. Switch the main fuse to OFF. See page 42.
4. Remove the rear wing on the relevant side.
See page 10.
5. Unplug the magnetic brake cable at the
contact on the cable. See illustration.
6. Remove the protective plate, which is held in
place with three screws. See illustration.
Thread the magnetic brake cable and, on
chassis with lights, the light cabling through
the plate's cable duct. Note the cable layout for
subsequent fitting.
7. Loosen the cable from the magnetic brake by
pulling the cable sheath down and pulling the
cable out through the cable holder groove.
The contact on the magnetic brake cable.
Pull the cable sheath down and pull the cable out
through the cable holder groove.
24