Permobil K450 Service Manual page 38

Control panel
Control panel
Removal
1. Switch off the main power switch on the
control panel.
2. Remove the cable ties holding the control
panel cable in place under the arm rest. Note
the positions of the cable ties for subsequent
fitting.
3. Unplug the control panel cable at the contact
on the cable.
4. Remove the control panel (1), which is held in
place with two screws underneath (see
illustration). These two screws also hold the
bracket for the ICS control panel (2), if there is
one fitted (see illustration).
Fitting
Fit in the reverse order.
Removal incl. bracket
1. Switch off the main power switch on the
control panel.
2. Remove the cable ties holding the control
panel cable in place under the arm rest. Note
the positions of the cable ties for subsequent
fitting.
3. Unplug the control panel cable at the contact
on the cable.
4. Loosen and remove the screw locking the
panel bracket's position. See illustration.
5. Remove the control panel incl. bracket by
pulling it straight forward.
Fitting
Fit in the reverse order.
1
The control panel is held in place with two screws.
The position of the control panel's bracket is
locked with a screw.
38
2